WiFi Module V1.0 – ESP8266
Esta página aún no está disponible en tu idioma.
The WiFi radio is developed around the very popular ESP8266 module used in many IoT projects. The WiFi module V1.0 comes with a standard JST-GH, allowing you to establish a UDP connection with your computer or mobile device and use mobile ground stations.
Comes with the latest Ardupilot ESP8266 firmware developed by Andrew Tridge. This new firmware has a nice web interface, MavLink2 support, and an easier way to do future updates via the web interface.
Purchase Wifi Module
Normal Usage
Section titled “Normal Usage”If connected to Serial1/Telem1 these parameters should be set on the autopilot (if using another telemetry port, replace the “1” in the parameter name with the telemetry port’s number):
- SERIAL1_PROTOCOL = 2 (MAVLink2) or 1 (MAVLink1)
- SERIAL1_BAUD = 921 (921600 baud)
If you have problems connecting, it may help to set BRD_SER1_RTSCTS = 0 to disable flow control although this is not normally necessary
Pinout
Section titled “Pinout”| Pin | Signal | Volt |
|---|---|---|
| 1 (Red) | VCC in | 5V |
| 2 (Blk) | ESP RXD | 3.3V |
| 3 (Blk) | ESP TXD | 3.3V |
| 4 (Blk) | NC | NA |
| 5 (Blk) | NC | NA |
| 6 (Blk) | GND | GND |